Monday, May 3, 2021

Attaching the Side Greeblies

This finishing touches, putting the side greeblies on the top shell.

I already had velcro measured, cut, and stuck on, so the only thing left was to carefully place them on the top shell. I found out the placing the PCBS exactly in the center meant only using a 3x2 of PCBs, not 3x3. This is fine, as I now have leftovers for another droid.

I also stuck the dowel pairs (3 dowels per set) on the outer sides of each PCB.



And the final result looks great!



The only thing left to do is test drive this....





at

No comments:

Post a Comment

Subscribe to: Post Comments (Atom)

Mouse Droids First Halloween

Mouse Droid not only celebrated Halloween, but also her 6 month date of being relatively complete.  I learned the basics of servos with Ardu...

  • Test Drive: Success
    Today was test drive day, which was a great success! Test Drive footage: Doing some donuts: Alternative YouTube: https://www.youtube.com/cha...
  • Shell Prep
    I took about 20-30 minutes to clean off my ABS plastic Shell before painting. This is done to get dirt and dust off. Most guides say to use ...
  • Shell Work, plus Side Greeblies News
     In the scope of my Mouse Droid build, the most labor intensive part was always going to be cutting and sanding excess shell material. To fi...